|
|
07-27-2011, 09:06 AM
|
#1 |
|
Member
Join Date: Mar 2008
Location: Lafayette, IN
Posts: 103
|
Chuckster's intake install question
I recently installed Chuckster's single intake, removed the airbox and hoses and installed coaster plates. My question is about the "tubes" that went into the stock plate for the cold idle solenoids. Do you remove them and plug the rubber hoses that go to them or remove the hoses also and plug? I'm asking because I removed the tubes and plugged the hoses, but now I am having trouble adjusting idle and poor gas mileage and wonder if I did something wrong. (I have TFI fuel module and V & H dual baggers)
__________________
2003 1500 Nomad FI Cuckster's single plate Vance & Hines duals Dobeck TFI Login or Register to Remove Ads |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Arrived! Chuckster's Dual-Plate Intake mod | taranis | 1500 & 1600 Nomad | 14 | 01-06-2011 07:38 AM |
| Noise after intake install during decel | cocheese72 | Vulcan Nomad/Vaquero/Voyager | 15 | 11-15-2010 08:58 PM |
| just finished with the chuckster intake **Update | chucks1911 | Vulcan Nomad/Vaquero/Voyager | 28 | 11-08-2010 04:48 PM |
| Chuckster Dual Plate Intake Installation | Cajunrider | Engine | 0 | 11-08-2010 04:43 PM |
| *SOLD*Chuckster's dual plate air intake system | Jared | Parts & Accessories | 8 | 09-09-2010 10:51 PM |
Threaded Mode