LED's + Flasher

[ve3hzz]

No problem, here is a closer look of it and my new fog lights installed and finally tested today (working fine).


I made a couple of brackets from some aluminum to move it inward for space for the connector.

And here is my fog lights installed:







And my other project


Have a few more like my reed valve block off plates, antenna redo in my fairing etc.

[blackdogbrian]

I like the fork mounts for the spots - simple, clean and effective!

[ve3hzz]

Originally Posted by blackdogbrian

I like the fork mounts for the spots - simple, clean and effective!

Thanks appreciate that. I was looking for a place to mount a set that was low enough yet didn't interfere with anything and as you say was easy (relative term..lol) to make. The problem there was the clearances and to ensure no issues with caliper etc.

I know the fuse boxes look a bit messy, but each has it's own circuit for both switched (left) and unswitched power for all accessories. I had these so cost was part of the factor in using this setup over a single box.

Now I just have to finish my GPS shroud and get it painted and put things back together and I'm done for this season...well for the most part ;)

Scott