|
05-06-2016, 12:51 PM | #1 |
Advanced Member
Join Date: Sep 2015
Posts: 542
|
Running two maps on PCV? Even with Ivan's ECU...
I am am thinking of leaving my aftermarket fuel processor in with Ivan's ECU flash because I will be reverting back to stock ECU occasionally and I want the ability to tweak either ECU. I will zero out map on Ivan's ECU however.
Anyone running two maps on their ECU? The instructions are a little vague so I called Tech support and they said to connect switch to one set of inputs only. I believe the software must be configured with a default map? When you close the switch I am guessing it will go to the other map? http://www.powercommander.com/downlo...I17-006.05.pdf Login or Register to Remove Ads |
|
05-07-2016, 07:09 AM | #2 |
Advanced Member
Join Date: Oct 2014
Location: South Florida
Posts: 710
|
Why would you need to return to the Stock ECU? Just curious.
__________________
2004 Vulcan 1500 Classic "Sasha" (SOLD) 2014 Vulcan Vaquero ABS SE "Candie" On the 1500, too much to list. On the Vaquero: V&H slash cut slip ons Power Commander 5 and Ivan-ized ECU Chuckster's BAK Aux Audio adapter with bluetooth receiver. Mustang 2 up Touring Seat w/ driver and passenger backrest Kuryakyn Longhorn highway pegs. Kawasaki 12 volt charger Longer 1600 meanstreak SE kickstand Full LED Daymaker light mod. |
|
05-07-2016, 08:54 AM | #3 |
Advanced Member
Join Date: Sep 2015
Posts: 542
|
|
|
05-07-2016, 12:18 PM | #4 |
Member
Join Date: Jul 2015
Location: S.E.WI.
Posts: 159
|
No need to spend 50.00 on the P.C. switch. I got a On / Off toggle switch from Radio Shack for 2.00. Latter I bought a Marine switch from Amazon. Use 2 wires that fit into the PCV. When you plug your P.C. into the PCV. It will ask you what position you want for which map.
__________________
Johnny Y PCV. Chucksters B.A.K. , D&D slip-ons. |
|
05-07-2016, 06:26 PM | #5 | |
Advanced Member
Join Date: Sep 2015
Posts: 542
|
Not buying their switch and know you can use anything. My question is do you install the switch on one set of inputs (1 or 2) and then configure in the software? The manual shows only one switch hooked up and doesn't say which set of inputs to install in.
Note: I haven't used the software yet so perhaps that is why I am wondering. Quote:
Login or Register to Remove Ads |
|
|