Bracket dimensions needed, please.

[sas]

Perhaps one of you 1500 Nomad owners who have the one piece chrome rail (Rear Fender Trim, PN K53020-247) that attaches under the chrome covers above the saddlebags and comes down along the outsides of the fender on your bike would be willing to help me out.

I’ll receive the chrome rail next week but there is a triangular shaped bracket that is missing from the rail. That bracket has two holes at the top and it attaches to the turn signal bar under the fender. In turn, there is a one hole tab on the rail that attaches to the bracket at the bottom. This bracket is what I don’t have and I’m going to have to fabricate one.

I need the dimensions of the width of the bracket left to right at the top and the space between the top two holes based on centerline. I also need the length top to bottom of the bracket and the single hole location up from the bottom of the triangle. If I recall correctly, when I put one of these rails on Lola, there was at least one bend below the two top holes. This would be to allow the bracket to line up with the single hole of the rail. I know this sounds a bit confusing, but if anyone would be willing to take these measurements for me I’d sure be greatful!