|
|
11-12-2017, 12:41 PM
|
#16 | |
|
Sr. Member
Join Date: Nov 2013
Location: The Newforest, England
Posts: 4,664
|
Quote:
..............Not done yet mate.  The shocks did'nt fit.I measured the diameter of the thread on the frame,and it matched the shocks.What i did'nt allow for was the shoulder that they fit onto.I got the old ones off,and wound 40psi into them from my brothers compressor.One of them leaked a bit of oil out of the valve.So i am going to take the valve housing out,and drain the bastards.Put new oil,air,and valves in.I reckon that should fix it.
__________________
 when this you see, remember me, and bear me in your mind, let all the world say what they may, speak of me as you find.
Login or Register to Remove Ads
Last edited by mick56; 11-12-2017 at 12:48 PM.
|
|
|
|
11-13-2017, 11:52 AM
|
#18 | |
|
Sr. Member
Join Date: Nov 2013
Location: The Newforest, England
Posts: 4,664
|
Quote:
__________________
when this you see, remember me, and bear me in your mind, let all the world say what they may, speak of me as you find.
|
|
|
|
|
11-26-2017, 06:19 PM
|
#19 |
|
Sr. Member
Join Date: Nov 2013
Location: The Newforest, England
Posts: 4,664
|
I fitted new valve cores today,pumped them up,and all is good.
 I did'nt even have to buy the cores,the bloke in the tyre bay gave them to me.Result
__________________
when this you see, remember me, and bear me in your mind, let all the world say what they may, speak of me as you find.
|
|
|
Linear Mode
