|
|
03-30-2018, 06:43 PM
|
#1 |
|
Jr. Member
Join Date: Jun 2017
Posts: 4
|
Stealth fairing from USA Trailer store
Anyone ever buy one of these? I did and the inner and outer won't go back together with brackets installed because there's to much fiberglass on the outer Fairing. Just curious if anyone has had this happen? I'm thinking of keeping it and trimming the fiberglass?
Login or Register to Remove Ads |
|
|
03-30-2018, 10:37 PM
|
#2 |
|
Member
Join Date: Dec 2016
Location: Lincolnton, NC
Posts: 106
|
I had to do a few modifications on mine, it works fine now.
|
|
|
|
03-31-2018, 01:55 PM
|
#3 |
|
Sr. Member
Join Date: Jul 2016
Location: Somewhere South of Alaska....
Posts: 2,351
|
On mine, inner and outter, I would have to hold together really tight by hand, get 1 screw on one side started, then press hard to get holes to line up correctly. Brackets spaced fairing off to one side. flipped and turned brackets, fit good now....
Its not bad, but its certainly not a 100% Top quality fairing. Would I do it again? Yes, since I was installing custom stuff, doing custom cutting....
__________________
 --------------------- Don't start no schit, there won't be no schit.... *My Sarcasm is directly proportional to the amount of Stupidity involved* --------------------- VBA#03239 VROC#37400 VRA --------------------- 2014 Vaquero 2001 Nomad FI 2003 Street Glide (sold) 1500 Meanie, fresh rebuild (sold) 90s BUBF Bobber (sold) 2001 UltraCycle FatPounder (Sold) 1975 HD ElectraGlide (Sold) 1982 Kawasaki Z1 Chopper (Sold) Suck It Up & Ride! 
|
|
|
|
04-01-2018, 12:19 PM
|
#4 |
|
Member
Join Date: Dec 2016
Location: Lincolnton, NC
Posts: 106
|
I took 4 fender washers, and made tapered spacers between the fairing and the mounts
|
|
|
Linear Mode
