Vaquero tail end mods

[skullbagger]

Originally Posted by jestephens

It's the HD Daymaker LED headlight

thanks Jay your bike looks good!
lots of work that paid off. How hard was the install was it a good fit .
does the connector match our vaq's

[napom]

Originally Posted by c3po

After an extensive search of flag poles for the Vaquero, and finding none that appealed to me....I made my own!

Nice looking mounts . . . and you have the right flag flying next to Old Glory! I need to get a replacement as mine fell off somewhere in New England . . .

[jestephens]

Originally Posted by skullbagger

thanks Jay your bike looks good!
lots of work that paid off. How hard was the install was it a good fit .
does the connector match our vaq's

The connector is the exact same. Making the fit wasn't terribly difficult either. The only thing I had to trim was the trim ring from our stock headlight to fit over the new mounting ring(supplied with the HD light). That supplies during made the conversion MUCH easier than I had anticipated

[skullbagger]

Originally Posted by jestephens

The connector is the exact same. Making the fit wasn't terribly difficult either. The only thing I had to trim was the trim ring from our stock headlight to fit over the new mounting ring(supplied with the HD light). That supplies during made the conversion MUCH easier than I had anticipated

thanks Jay
awesome

[Kawasakieric]

Question for those that used the Plasma Rod rear turn signals. What flasher did you use or was the stocker sufficient? I'm looking to take off the stock turn signals and just use the rods. I don't want them to flash quicker than stock so I figured a led flasher will be needed.

[c3po]

I opted top leave the stock turn signals on for now. I felt it gave me more light. I believe Custom Dynamics sells an 'equalizer' that eliminates the quick flashing of add on LEDs

[Kawasakieric]

Originally Posted by c3po

I opted top leave the stock turn signals on for now. I felt it gave me more light. I believe Custom Dynamics sells an 'equalizer' that eliminates the quick flashing of add on LEDs

Thanks I figured I would need a load equalizer or led flasher.

[JTJL]

Kawasakierc, I bought the dual color rods. They had the chip already wired into the lights. Then it was a matter of pulling the old lights off and wiring and mounting the plasma rods. One thing I can say is I had aproblem with one of the rods being iintermittent when it was supposed to be in running light mode. A few emails and some fiddling with wires and the chip and they shipped me two new wire bundles. Now they are working as should.

[sshorenomad]

those led are not water proof ? i cant see did you cover them ?

awesome look, I dig the carbon on black look!!