|
04-29-2017, 11:03 PM | #1 |
Jr. Member
Join Date: May 2015
Location: Monroe,NC
Posts: 17
|
Kuryakyn Run-Turn-Brake Controller
Want to install the Run-Turn-Controller on my Nomad. Took the seat off and tracked the wiring harness to the stop and tail light but really didn't see a good place to install it. Really tight under the seat and hate to install it in the middle of the wheel well. Although there is plenty of room it gets wet and muddy there. If anyone's done this mod let me know where you placed it.
Login or Register to Remove Ads |
|
04-29-2017, 11:13 PM | #2 |
Sr. Member
Join Date: Jul 2016
Location: Somewhere South of Alaska....
Posts: 2,351
|
I got my extra fuse block, run/turn messowires setup, airhorn, relays under my lefthand side cover....I took out the piece of plastic shelving and did away with that toolpouch holding setup....after all, I got saddlebags, the I got duffle bags, then I got tool bags....
__________________
--------------------- Don't start no schit, there won't be no schit.... *My Sarcasm is directly proportional to the amount of Stupidity involved* --------------------- VBA#03239 VROC#37400 VRA --------------------- 2014 Vaquero 2001 Nomad FI 2003 Street Glide (sold) 1500 Meanie, fresh rebuild (sold) 90s BUBF Bobber (sold) 2001 UltraCycle FatPounder (Sold) 1975 HD ElectraGlide (Sold) 1982 Kawasaki Z1 Chopper (Sold) Suck It Up & Ride! |
|
04-30-2017, 08:01 AM | #3 |
Sr. Member
Join Date: Jan 2008
Location: Cartersville, Georgia
Posts: 4,838
|
When I installed my Kuryakyn Run-Turn-Brake Controller, the only one they offered was a universal unit, not plug~n~play. Where I installed mine was under the seat, between the battery compartment and the rear fender right where the quick disconnect is to the rear wires. It is tight, and due to the lack of room, I soldered it in. I would have preferred to use bullet connectors, but there wasn't room for them, and I don't plan on removing it, so hard wiring worked for me.
__________________
Cliff "VulcanE" Evans 2005 Blue & Silver 1600 Nomad VBA # 320 VROC # 20381 |
|
04-30-2017, 08:47 AM | #4 |
Jr. Member
Join Date: May 2015
Location: Monroe,NC
Posts: 17
|
Thanks for the answers. Sounds like Ill need to solder it in also. It is tight in there under the seat.
|
|
05-03-2017, 03:17 PM | #5 |
Advanced Member
Join Date: Aug 2012
Location: Morrow, Ga.
Posts: 830
|
Let us know how it turns out. I may do mine if it turns out good.
__________________
02 1500 Nomad (07 1600 Motor) 160,000 Red & Black 12" mini apes Galfer lines (6' over) EJK Dobeck Reckless Fairing. Led H4 headlight All LED lights Rockford Fosgate radio Login or Register to Remove Ads |
|