Go Back   Vulcan Bagger Forums > Technical :: Maintenance :: Performance > Instructions, Tutorials, Part Info, Recal Info, etc. > Electrical

Reply
 
Thread Tools Search this Thread Display Modes
Old 05-09-2011, 06:41 AM   #1
ringadingh   ringadingh is offline
 
ringadingh's Avatar
 
Join Date: Aug 2007
Location: Newmarket Ontario Canada
Posts: 35,387
Why do I want to use a relay?

Heres a great explanation of why to use a relay when wiring accessories to your bike. Thanks to Yellow Jacket !!

Suppose that you wanted to wire up your lightbar so that it would come on with the running lights. You could wire the lightbar directly into one of the running light wires. However, since the running lights are on a 10 amp fuse and relatively small wires, as soon as you turned it on with the light bar hooked up the fuse would blow. So, then you could say to your self, "Self, I'll just replace the fuse with a bigger fuse, say a 20 amp fuse." Voila! The light bar works and the fuse doesn't blow! Of course, since you're now drawing a lot more amps through those small wires than they are rated for the wires get hot. Before long the wires get hot enough to melt the insulation. Then they melt the insulation on other wires that they may be touching. The fuse doesn't blow until the mess gets shorted to ground but by then it's too late. You will now be looking for a replacement wiring harness. Not much fun.

Now, if you were to take a 30 amp relay (which is just an electrically activated switch), connect a wire from the battery (or an auxillary fuse panel) sufficient to handle the amp draw of the light bar and connect a wire from the relay to the light bar, again with the proper size wire you could now run the light bar with out melting any insulation or burning any wires.

All you need now is something to turn the relay on and off. For this you can simply connect a wire the same size as that which runs the running lamps to the coil connection on the relay. Connect a ground wire to the other coil connection.

The coil of the relay draws only a tiny amount of current so the running lamp circuit won't be overloaded.

When the running lamps come on, the relay (switch) will close and turn on the light bar.
When the running lamps go off, the relay (switch) will open and turn off the light bar.

All will be well.

P.S. If you connect the light bar to an aux fuse panel, you don't need to wire it to another relay, as long as the total load on the fuse panel doesn't exceed the rating of the relay and the wires feeding the fuse panel.

__________________

2002 Nomad aka Bountyhunter
VBA #27
VROC #18951



Login or Register to Remove Ads
 
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Why do I want to use a relay? Jared 1500 & 1600 Nomad 23 05-09-2011 08:23 PM
relay wiring question minst7877 Vulcan Nomad/Vaquero/Voyager 14 03-31-2011 07:10 PM
Turn Signal Relay Moose SouthEast Group 25 02-16-2011 10:19 PM
Relay for Driving lights chuckster131 1700 Nomad, Vaquero & Voyager 11 12-07-2010 08:50 PM
Horn relay? markpenn1 Vulcan Nomad/Vaquero/Voyager 5 09-21-2010 10:33 AM



Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.