|
03-24-2010, 07:36 AM | #2 |
Sr. Member
Join Date: Jan 2008
Location: Cartersville, Georgia
Posts: 4,838
|
Light Bar Visor
The way I did mine was to remove the light from the bar (remove the screw on the bottom, and pivot the bezel up), un-plug the light. Look at the 3 clips holding the lens in, and note the orientation of them. Using a pair of needle nose pliers, grip one side of a clip and get it to come down and out (watch out and don't let it fly off somewhere). Do the same on the second, then you can use your fingers on the 3rd. After you get your lens out, put the visor in from the inside, get it straight, and put the lens back in, and very carefully replace the clips, then remount the light. Don't forget to re-plug the wire to the bulb. ;)
__________________
Cliff "VulcanE" Evans 2005 Blue & Silver 1600 Nomad VBA # 320 VROC # 20381 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
light bar | joe3407nomad | 1500 & 1600 Nomad | 1 | 06-10-2010 12:22 PM |
Light Bar | towering | Vulcan Nomad/Vaquero/Voyager | 5 | 08-12-2009 09:18 AM |
Light bar | nomadrider | 1500 & 1600 Nomad | 4 | 08-01-2009 08:53 AM |
WHAT LIGHT BAR ARE YOU USING | kawbuc | Vulcan Nomad/Vaquero/Voyager | 22 | 02-15-2009 09:54 PM |
1600 Light Bar | radco | Parts & Accessories | 13 | 02-06-2009 04:53 PM |