Register FAQ Upgrade Membership Community Calendar Today's Posts Search
Go Back   Vulcan Bagger Forums > Technical :: Maintenance :: Performance > 1500 & 1600 Nomad

Reply
 
Thread Tools Search this Thread Display Modes
Old 10-18-2008, 03:00 PM   #1
dogdoc   dogdoc is offline
Top Contributor
 
Join Date: Jul 2007
Posts: 5,263
TFI Installed.

Well I got her dun this morning. I removed my tank to make it easy. I was dreading this but now I have done it, its EASY!! 10- 15 minutes and tanks offf, no gas drips out, I had 2 gallons in it. The TFI installs fairly easily and routes well going to the left side cover.

Set mine according to directions and others advice:
Pot #1: 2:30
Pot #2 5:30
Pot #3 OFF
Pot #4 9:00

This is a good place to start, since I had 93 gas in it and will go to 87, settings will change a little Im sure. I have a K&N on the right side with ISC unhooked. V&H baggers.

Results: WWWWOOOOWWWW!!!!!! Bike runs ALOT harder/faster in all gears. NO ping in any gear (even 5th) on a hard roll on. Spun rear tire in 2nd gear at about 25 mph when I goosed it. it will throw you back noticeable in all gears. And as BD said motor runs alot cooler. I highly rec'd it to anybody. This is the way this bike should run now.



Login or Register to Remove Ads
 
Reply With Quote
Reply



Similar Threads
Thread Thread Starter Forum Replies Last Post
Installed it myself!!! markclark57 1500 & 1600 Nomad 40 06-18-2011 11:39 AM
C/T installed! bigsid1 Vulcan Nomad/Vaquero/Voyager 7 11-06-2009 11:35 PM
TFI installed kudzufarmer 1500 & 1600 Nomad 13 10-30-2009 01:44 PM
TFI Installed Today Todd 1500 & 1600 Nomad 13 01-01-2009 07:20 PM
Well it is done. V&H Baggers installed dhomoney 1500 & 1600 Nomad 18 12-12-2008 01:02 PM



Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.