Oil leak
azpnshi
If the clutch push rod seal pops out, you can either push the old one back in or replace it with a new one. Regardless which way you go, you should put a small amount of gasket glue or equivalent on the outer edge before pushing it back in. This should stop it from popping back out. Also, push it in only far enough to be flush with the outside of the casing. If you push it in to far, it can fall inside the engine and will ruin your day! :)
__________________
________________________________
"lomax"
2014 Voyager
Mike Donahue
Morinville, AB
VBA#17
"Every day above ground is a good one!"
_________________________________
|