Power commander V

[s/c4095]

Just purchased a PCV fuel and Ign. and was thown off with the wiring. It say to connect to stock yellow and stock black. Would this be the yellow with black bands on it, and the black with yellow bands on it? Also it has the wiring for the coils but there is nothing on the installation pages that shows the wiring to the coils. Power Commanders web site doe'snt show it also. Called and they sent me an email that would not open. Any help would be great. Thanks

[redjay]

I thought the power Commander was just like any other aftermarket TFI ?
Just a black wire going to the battery negative ? Obviuously not.

[smokey]

Just purchased a PCV fuel and Ign. and was thown off with the wiring. It say to connect to stock yellow and stock black. Would this be the yellow with black bands on it, and the black with yellow bands on it? Also it has the wiring for the coils but there is nothing on the installation pages that shows the wiring to the coils. Power Commanders web site doe'snt show it also. Called and they sent me an email that would not open. Any help would be great. Thanks

http://www.powercommander.com/downloads/17-033/install/pcv/eng17-033.03.pdf

Pretty straightforward, if I could figure it out, anyone can. there is a connect under the seat, which is the two wires you refer too, and then the connection by the intake. By the way, my 2010 Voyager does not have the coil connections listed in the installation instruction, I don't know what year your bike is, but the installation instructions for mine says 2009 - 2011. That is for the PCV only, you have the coil connections due to having the ignition feature. I am pretty sure the wires I connect to are solid yellow and solid black as indicated in the instructions,