Dangerous water ?

[jandijkgraaf]

I would like to know how many of you guys use a car wash
high pressure cleaning solution for cleaning the bike after a
long dusty ride.
I know it's not recommended because of possible electrical
system issues,but I always did it with my former bikes and never
had any problems,as long as I took an immidiate ride after to
properly dry the bike by wind.

Actually..I plan to do it tomorrow because it's very nessessary.
Cleaning this way will save me a lot of time..no doubt.
But I would like to hear your opinion first.
So please..how dangerous exactly is it?
Don't want to end up with some dead bike or something.

[ringadingh]

I have done it with a couple of my other bikes, but Im very carefull about where I point the wand and how close I am to certain parts.
Its great for the lower part of the motor and wheels, but be carefull around the top of the bike.

[macmac]

If you keep bak a bit , it isn't that big a deal unless you soak the expose air filter a bit too much if you have them, and or the fill the plug wells. Don't.

Keep back a bit on the engine black paint too. It lifts pretty easy. The area near the oil filler plug on my bike keeps peeling off black paint. I just use a bottle touch up there, but the metal below isn't paint friendly a bit.

[Blue Rebel]

I've never used a pressure hose, only done it by hand.

[waterman]

Hand only here as well. The hand wash is free compared to the $2 for the car wash.

[blowndodge]

I've never had to hand wash my bike... It never get dirty enough that I need to take a hose to it..

[usranger74]

Hand wash only.

[jandijkgraaf]

http://s2.images.proboards.com/grin.gif
I've never had to hand wash my bike... It never get dirty enough that I need to take a hose to it..

You must live on some other planet then.
I certainly need to clean the beast.
The easy way..that's why. http://s2.images.proboards.com/grin.gif

[dantama]

I ride dirt roads a lot, but the worst is the baked on road spray from riding in the rain.

I almost always use a car wash. I've done it with all my Nomads. I put 63,000 miles on my first Nomad, so if "car wash" problems were going to surface, that should be long enough for problems to start showing. None ever did.

I don't spray near bearings, like the axles and steering stem. I spray near them, but not at them. I don't spray a full stream at the electrical switches or speedo housing spark plugs etc. Though I do spay the low pressure spot free rinse on them without worrying, other than the spark plugs.

I don't ever use the brush. I don't ever use that sand infested paint remover on cars or anything, I just use the spray wand.

If it has the super soap I put the money in, then use the rinse water that was left in the hose to spray the pipes to cool them while waiting for the soap to reach the wand. Then when the soap gets there I hit the windshield and front bits first to let the bugs marinate. After getting the rest of the bike really good, I skip wash and go straight to the high pressure rinse. I use the rinse to blast the dirt off getting the windshield and front chrome last, then go to the spot free rinse. Be sure to cover the whole bike, behind the windshield and everywhere and you won't have any spots anywhere.

That's the routine I've done with all my bikes, and even with high miles I've never had a problem with my paint, bearings, electrical or anything.

For those who only hand wash, if you enjoy it great. It's a good way to spot damage or loose bits because you are touching everything. I'm mostly just lazy. I love having a clean bike, and it takes 4 minutes start to finish to have a completely clean bike.

[jandijkgraaf]

I have done it with a couple of my other bikes, but Im very carefull about where I point the wand and how close I am to certain parts.
Its great for the lower part of the motor and wheels, but be carefull around the top of the bike.

That's the best comment so far..
Avoid critical areas is common sense.
Good..who's next?
Because..I think it's an important time and work
saving issue.

[VulcanE]

I have only used the car wash a few times, but it is only after riding in the rain. Like others have said, just don't get too close with the wand, especially on the engine and other electrical areas, AND the radiator cooling fins.

[jandijkgraaf]

I ride dirt roads a lot, but the worst is the baked on road spray from riding in the rain.

I almost always use a car wash. I've done it with all my Nomads. I put 63,000 miles on my first Nomad, so if "car wash" problems were going to surface, that should be long enough for problems to start showing. None ever did.

I don't spray near bearings, like the axles and steering stem. I spray near them, but not at them. I don't spray a full stream at the electrical switches or speedo housing spark plugs etc. Though I do spay the low pressure spot free rinse on them without worrying, other than the spark plugs.

I don't ever use the brush. I don't ever use that sand infested paint remover on cars or anything, I just use the spray wand.

If it has the super soap I put the money in, then use the rinse water that was left in the hose to spray the pipes to cool them while waiting for the soap to reach the wand. Then when the soap gets there I hit the windshield and front bits first to let the bugs marinate. After getting the rest of the bike really good, I skip wash and go straight to the high pressure rinse. I use the rinse to blast the dirt off getting the windshield and front chrome last, then go to the spot free rinse. Be sure to cover the whole bike, behind the windshield and everywhere and you won't have any spots anywhere.

That's the routine I've done with all my bikes, and even with high miles I've never had a problem with my paint, bearings, electrical or anything.

For those who only hand wash, if you enjoy it great. It's a good way to spot damage or loose bits because you are touching everything. I'm mostly just lazy. I love having a clean bike, and it takes 4 minutes start to finish to have a completely clean bike.

That one is even better!
Thx..very much.

[jandreu]

I go the hand wash way. Bike on lift, bags off, detailing brush. Use hot water and dish soap. Then I use a leaf blower to air dry the bike followed by a quick clean cloth on the chrome and wax the paint every other washing.
Takes about 45 minutes each time but I like a clean bike and I live in a heavy salt spray area. Also I can inspect everything as I go.

[scott2007nomad]

Used a garden hose a couple of times but haven't felt a need for the high pressure car wash.

Mostly use the "detail" spray bottle stuff and lemon Pledge.

[oldbikers]

The easy way is to get some Bike Brite cover the bike with it and then rinse it off and dry it with a leaf blower.

[Yellow Jacket]

I just go to bike or car shows and let the girls in bikinis wash it.

[AlabamaNomadRider]

I have only used car washes one time. I mostly just use a cleaner/wax that was designed for the Goldwing. Spray it on and then wipe it off. Gone is the dust and all that is left is the shine. Water and a soft cloth for the windshield.

[coacha]

I just go to bike or car shows and let the girls in bikinis wash it.

I thought I saw your Nomad at the bikini car wash. http://s2.images.proboards.com/grin.gif

[bokobob]

Bike doesnt get very dirty here in NC and I usually just wipe down teh fenders and tank with paper towels adn windex.....occasionally I spray off the wheels adn lower parts of bike with a garden hose adn ride aroudn teh block to dry it off..

[pastorgumby]

I've read here or somewhere else a comment about using Simply Green to wash your Nomad?
I haven't had a need to give mine a "proper" wash, but I always use Lemon Pledge and a clean cloth to add shine and take away dust.

[audiogooroo]

I just go to bike or car shows and let the girls in bikinis wash it.

I thought I saw your Nomad at the bikini car wash. http://s2.images.proboards.com/grin.gif
Were you working the wash Ron? ;)

[jandreu]

PG..Simple Green, over time, will removed the wrinkle black on the motor. I have a Harley that had Wrinkle Black jugs that I cleaned with simple green on purpose to slowly remove the black.

[jandijkgraaf]

THX..to all for your watery reply...
I've been riding for the last 6 days in hot weather,camping out.
I've made a thousant miles and lost a bundle on go juice..ha..
So..I was'nt able to reply.
I found a way to dry clean the bike with a product called Vulcanet.
It's a tube containing just impregnated rags witch will clean
everything from paint to chrome and all else,without the use of
water.
Ofcourse..cleaning that way is a job for half a day.
Not exactly the way I was looking for.
Just..to be on the safe side.

[duneseven]

I use the car wash on road trips as all my supplies r at home. I have never had a problems, wait I take that back why do u always run out of water before your done? damn thing eats quarters like they r skittles

[foztex]

I wash mine with a belt sander and spray paint. http://s2.images.proboards.com/grin.gif http://s2.images.proboards.com/grin.gif

[Kawhead]

When my wife is done with the house, she washes it for me.

[lonewolf]

When my wife is done with the house, she washes it for me.
ATTA BOY !!!! ;) ;) ;)

[macmac]

When my wife is done with the house, she washes it for me.

I saved one MAN! Yay!!!!!!! Now thar's 2 knuckle draggers! http://s2.images.proboards.com/grin.gif

[poppy]

When <s>my wife is</s> I am done with the house, <s>she washes it for me</s> then I wash the bike!

Edited for correct version..... http://s2.images.proboards.com/grin.gif http://s2.images.proboards.com/grin.gif http://s2.images.proboards.com/grin.gif

[macmac]

ouch!

[cactusjack]

When my wife is done with the house, she washes it for me.

I hope when she's done with the bike, she whips you up a plate of biscuits and mustard. ::)

[jandijkgraaf]

I wash mine with a belt sander and spray paint. http://s2.images.proboards.com/grin.gif http://s2.images.proboards.com/grin.gif

Seems you do a fine job that way..
Like your red and silver b.t.w..
Hard to find here in europe...
Looks fine to me!